User's Manual

bebob factory GmbH – Höglwörtherstr. 350 – D-81379 München – Tel.: [phone]
www.bebob.de
November 2019
Charging
• Never load unattended
• Wait 30 Minutes after discharge before you put the battery on a charger.
• The bebob V45micro battery can be charged with an external bebob charger (or
equivalent) with Lithium-ion (Li-ion) charging ability.
• Approximate charge time may vary depending on charger and temperature.
• bebob V45micro can be charged in ambient temperature for optimum performance at 10°C
- 30°C.
• bebob V45micro batteries can be recharged in any charge condition.
Discharging
• Maximum load is 10.0A. When using the battery with video or lighting equipment, power
consumption of the equipment must be 10.0A or below. For the protection of the battery, a
load of 10.0A or over may activate the internal protection circuit and stop supply of power.
In this case the status led will turn red.
• The battery can be used in ambient temperature of - 20°C - + 55°C.
Camera Data Communication
• Blue leds: Arri/Sony Data Protocol
• Red leds: Red Data Protocol
• To switch between both status, press the Check button for 5s
Status led
• Status led lighting Green: Full Capacity over 70% of New
• Status led lighting Yellow: Full Capacity between 50% and 70% of New
• Status led lighting Red: Full Capacity under 50% of New
Flash Light
• To switch On/Off press the Check Button Twice