User Manual
80
Description Reason Solutions
The tail oscillates in
horizontal position slowly
and irregularly while
hovering.
The HeadingLock gain
is too high.
- Reduce the HeadingLock gain in
parameters menu point D by one step
and increase the tail gain at your
transmitter.
- Check the linkage and mechanics for
absolute free movement without hard
points.
The tail oscillates in
vertical position.
This oscillation is
caused by the rotor
head.
- Decrease cyclic gain (Dial 1).
- Use another rotor head dampening that
better ts to rotor head speed (the
higher the head speed, the harder the
dampening should be).
During slow hovering
pirouettes, the helicopter
is rolling out.
The pirouette
optimization setting is
wrong
- Adjust the pirouette optimization in
setup point N correctly.
Status-LED ashes in
operation mode, e.g.
after landing.
During operation a
software - reset
occurred.
- The receiver power supply does not
seem to be sucient. The voltage during
operation dropped in a critical area or
there was a discharge or transfer of high
voltage.
If you need more support you can connect to the forum at WWW.BEASTX.COM.