User Manual

8
Please note that these instructions are
only valid for the MICROBEAST rmware Version 3.x.x !
The delivered software version is printed on a sticker on the outside of the MICROBEAST packaging.
You can also read it out on a computer by using the optional USB2SYS Interface and you can directly
read on the MICROBEAST unit during the initialization phase, what rmware version your MICROBEAST
is running:
The MICROBEAST rst carries out a brief LED test by lighting up all menu LEDs simultaneously, and
cycling the Status-LED color. Then for about 3 seconds, the Status-LED lights red while the menu LEDs
A - G display the rst digit of the rmware version, and the LEDs H - N the second digit of the rm-
ware version. Only the rst digit of the rmware version is of importance!
If only LED B is lighting or if the display on initialization is not as described, but ONLY a running light
of all menu LEDs A - N, then the MICROBEAST is running an older version. In this case we recommend
updating to the latest rmware version. If you like to continue to use the older rmware version, you
must also use the appropriate instructions and not this manual!
You will get more information about the version display in section 11 of this manual.
Firmware version 3.x.x
On the rst column LEDs A and B must light corresponding to digit 3.
LEDs H - N are irrelevant for the purposes of this instruction manual.
GENERAL INFORMATION