User Manual

77
Description Reason Solutions
The MICROBEAST does
not initialize.
The Status-LED is ashing red.
The MICROBEAST
signals a sensor
failure
- Helicopter must stand absolutely still
during initialization process.
- Strong wind can shake the helicopter and
therefore the sensors. Lay it on the side
during the initialization.
- Don’t initialize on a vibrating support, like
a car hood or trunk with a running motor.
Turn o the motor!
- Sensors are damaged.
Return MICROBEAST for repair
The Menu LEDs H to N are
running up and down,
MICROBEAST does not
initialize.
The MICROBEAST
has no valid
signal from the
receiver.
- Check the wiring. Mainly check receiver
wires for polarity on both sides and correct
plugging (no vertical oset by one pin)
- In case of 2.4GHz, check the transmitter-
receiver binding.
- Check the correct receiver type is set,
chapter 5.
12. TROUBLE SHOOTING