User Manual
65
B Control behavior
At parameter menu point B you can choose between dierent control behaviors for your helicopter. This
includes the maximum rotation rate of the helicopter as well as how sensitive the MICROBEAST will react to
stick inputs for aileron, elevator and rudder around the stick centre.
Factory setting for this option is “sport“! This should be suitable for most pilots.
If you are a rather inexperienced model pilot it is absolutely suggested to select the option „normal” for the
rst ights. In this state the rotation rate on cyclic and tail is very much decreased and the stick inputs around
center are very gentle. Then nd your individual preference by increasing the option step by step.
The choice is done by moving the tail stick in one direction until the LED indicates the desired color and
state.
If you are not satised with the presets, you may adjust the control behavior completely through your
remote control. To do so, set the control behavior to “transmitter” (Status-LED “blue“).
The maximum rotation rate for aileron, elevator and rudder can then be adjusted by increasing or
decreasing the servo travel for the corresponding function in your transmitter. Approx. 100% stick
throw (servo throw in the transmiter) are equivalent to full rotation rate in this mode. In this mode,
there is no expo programmed in the MICROBEAST and you also have to set this in your
transmitter.
Status-LED Control behavior
purple normal
red ashing sport*
red pro
blue ashing extreme
blue transmitter
o user dened
*
Factory Setting