User Manual
64
A Swashplate cyclic center adjustment
The rst menu point in the parameters menu gives you the possibility to easily adjust your servo
centers on the ying eld as for instance your helicopter is wobbling during pirouettes or when it
doesn’t climb out straight on quick pitch inputs.
Never use the trim functions of your remote control!
The MICROBEAST will see trim as a control command and not as servo trim.
Contrary to centering every single servo in the setup menu point G, here you are able to directly adjust
aileron and elevator without taking care about the single servos. However, the collective pitch cannot
be adjusted here.
Similar to the digital trim function of most transmitters here at parameter menu point A you can
adjust the swashplate “one click“ by shortly moving the aileron or elevator stick in the desired direction.
If you want to trim the swashplate any further repeat tapping the stick several times or simply hold the
control stick pushed for a longer time to automatically perform several trim steps.
During the sub trim procedure you can delete the just performed trimming by moving the tail stick in
any direction. Additionally the color of the Status-LED gives you an approximate indication of how
much you did trim.
But remember that this function as opposed to the digital trim of the transmitter is not
a separate trim function. Here you directly adjust the servo centers as well as you would set servo
centers in the setup menu point G. If the new position is saved once then this corresponds well to the
new servo center position in the setup menu point G. A subsequent reset to the previous state is not
possible anymore!
Push the button to save the conguration and to proceed to parameter menu point B.