User Manual

60
8. DIALS AND TAIL GYRO GAIN
To adjust the dials please only use the original plastic BEASTX adjustment tool to prevent damage to
the dials!
8.1 Swashplate: cyclic gain (Dial 1)
Turn dial 1 clockwise to increase the swashplate gain.
The factory setting for the dial is horizontal which corresponds to 100% swashplate gain. For your rst
ights we suggest not changing this setting. However, when using very small helicopters (such as 250
or 450 size), reduce the swashplate gain slightly.
In general the higher the gain the harder the helicopter will stop after cyclic moves and the helicopter
will feel more stable in the air. If the gain is too high the helicopter feels spongy and tends to oscillate
especially on the elevator axis.
If the gain is too low the helicopter does not stop precisely after a cyclic movement and feels unstable
in fast forward ight.
Status-LED
Tail gyro mode
o, blue ashing, blue = HeadingLock
purple = Normal-Rate mode
Menu LEDs:
The amount of tail gain A=0% to N=100%
(only after powering up or when adjusting the gain)
Dial 1: cyclic gain
Dial 2: direct cyclic feed forward
Dial 3: tail dynamic
Fig. 33