User Manual
55
M Setting the swashplate sensor directions
At setup menu point M, you check if the sensors for aileron and elevator are working in the correct direction.
This can be directly veried in this menu point: If you roll or tilt the helicopter by hand the swashplate has to steer
against this movement. Please refer to this on the next pages Fig. 30 and 31.
If this is not correct, you can reverse the sensor directions by moving the tail stick in one direction. For
conrmation you will see that the Status-LED changes color. Repeat this step until both sensors are
correcting in the correct direction.
There are four possible displays for control to choose from, one will be correct:
Push the button to save the conguration and to proceed to setup menu point N.
When tilting the helicopter forward the swashplate has to move backwards, when tilting the heli-
copter to the back, the swashplate has to compensate forward. Same thing applies to the roll axis,
when you roll the helicopter to the left the swashplate has to steer right and vice versa. Basically the
swashplate has to remain horizontal while banking the helicopter.
Sensor direction
Status-LED Elevator Aileron
o reversed reversed
purple reversed normal
red normal reversed
blue normal* normal*
*
Factory Setting