User Manual
53
K Adjusting the collective pitch range
At setup point K you adjust the maximum desired negative and positive collective pitch.
Move the pitch stick all the way up and stay there. Now you can increase or decrease the maximum amount
of pitch using the tail stick.
When you adjusted the desired maximum pitch angle, move the pitch stick all the way down and again in-
crease or decrease the pitch to the minimum desired value using the tail stick.
Don‘t use any pitch curves in your transmitter while doing these adjustments. Later on for the ights,
you can adjust your pitch curves as you like and are used to. Setup menu point K solely serves to teach
the MICROBEAST the maximum used pitch range.
Push the button to save the conguration and to proceed to setup menu point L.
At this point, verify again that the demanded pitch direction on the transmitter is in the correct
direction for the model. Otherwise use your transmitter‘s servo reversing function for the pitch channel
to correct this as already described in section I.