User Manual
50
I Setting the swashplate servo directions
At setup menu point I, you adjust the correct swashplate servo directions. To facilitate this setup, you
don’t need to adjust every servo by its own, but just try the 4 possible combinations.
Move the pitch stick and check if the swashplate moves horizontally up and down. The direction itself
is not yet important. If one or more servos are not running in the right direction, just choose another
combination by giving a short rudder input. Repeat this rudder input until all servos are running in the
same direction.
Check now, if your control directions of aileron, elevator and pitch are correct. If this is not the
case, you have to use the servo reverse feature of your transmitter to reverse the appropriate control
function...
Push the button to save the conguration and to proceed to setup menu point J.
Note: This menu item will not be left automatically after 4 minutes, so you have plenty of time to adjust
the mechanical setup.
If the servos are still not reacting properly to aileron and elevator functions, check if the servos and
receiver wires are connected as described above in section 3.3 and chapter 4. Also check if the channel
assignment within receiver menu has been done correctly (section 5.2) if applicable.
Additionally verify the settings of your transmitter on any remaining mixer functions (see section 3.2).
Status-LED CH1 CH2 CH3
o normal reverse reverse
purple normal* normal * reverse *
red normal reverse normal
blue normal normal normal
*
Factory Settings
Servo directions