User Manual
45
If this is not the case you have to reverse the sensor direction. This happens by moving the tail stick
once into any direction. For conrmation you will see that the Status-LED will change its color.
At setup point F, you can nd this out very easily:
The gyro always tries to steer in the opposite direction of the rotation that is applied to the helicopter.
If you move the helicopter by hand around its vertical axis, the gyro must actuate a tail servo movement to
compensate this rotation. If for example you move the nose of the helicopter to the right, the gyro has to
steer left the same way as you would steer left with the rudder stick (see g. 24)
F Setting the Tail sensor direction
Here you have to check if the MICROBEAST‘s tail gyro does compensate into the right direction.
Status-LED Tail Sensor direction
red normal *
blue reversed
*
Factory Setting