User Manual
41
Please note that depending on the tail servo center position pulse length chosen at setup menu point C, you
may not be able to choose a frequency higher than 333Hz. This also applies to the “user dened“ setting which
might be limited to 333Hz (see also note at setup menu point C).
If you do not know what the maximum frequency tolerated by your servo is, please select not more
then 50Hz. A higher frequency can lead to failure of the servos!
Analog Servos usually tolerate only 50Hz. Digital servos usually allow higher frequencies, but this has to
be veried in the datasheet of the servo. You may need to check with the manufacturer of the servos.
On WWW.BEASTX.COM you can nd a list of parameters for the most common servos.
D Tail servo frequency
As with the swashplate servos at setup menu point B you can select at setup menu point D the
frequency for the tail servo.
To optimize the performance of the MICROBEAST tail gyro, the rule is the higher the better!
A good rudder servo should be capable of running at least 270Hz.
By moving the tail stick
repeatedly in one direction you
can choose the desired tail servo
frequency.
Status-LED Tail servo frequency
purple 50 Hz *
red ashing 165 Hz
red 270 Hz
blue ashing 333 Hz
blue 560 Hz
o User dened
*
Factory Setting