User Manual
40
There is a relationship between the setting of the tail servo center position pulse length and the tail servo
frequency (menu point D). If a pulse length is selected that does not allow a certain frequency, this fre-
quency is automatically reduced. The center position pulse-setting always has priority, since a servo can
run without problems at a too low frequency but can not be operated with an incorrect center position
pulse.
On WWW.BEASTX.COM you can nd a list of parameters for the most common servos.
The color of the Status-LED
shows the currently selected
servo center position pulse
length:
C Tail servo center position pulse length
At setup menu point C you can select the pulse length for the tail servo‘s center position. Almost all
commercially available servos work with 1520 μs. But there are a few special tail servos on the market
which use a dierent center position pulse length.
To select the desired servo center position pulse repeatedly move the tail stick in one direction until the
Status-LED glows in the correct color.
The option “user dened” allows you to dene your own setting with the PC software.
Push the button to save the conguration and to proceed to setup menu point D.
Status-LED Tail servo center position pulse length
purple 960 μs
red 760 μs
blue 1520 μs *
o User dened
*
Factory Setting