User Manual

4
CONTENTS
CONTENTS ...................................................................4
SAFETY NOTES ...............................................................6
GENERAL INFORMATION ......................................................8
1. INTRODUCTION ............................................................9
2. BOX CONTENT ............................................................10
3. MOUNTING AND CONNECTION .............................................11
3.1 Mounting the MICROBEAST unit ................................................11
3.2 Preparing a transmitter for ybarless ..............................................12
3.3 Servo connections and auxiliary channels ......................................13
4. Receiver connection .......................................................14
4.1 Connection of a standard receiver ..............................................15
4.2 Use of single-line receivers .....................................................18
5. Receiver type setup .......................................................24
5.1 Receiver type choice (receiver menu point A) ........................................24
5.2 Input channel assignments (receiver menu points B - H) ............................26
5.3 Programming the Failsafe (receiver menu point N) .............................31
6. SETUP PROCEDURE OVERVIEW .............................................32
6.1 Setup menu ...................................................................34
6.2 Parameter menu ...............................................................34
6.3 Example: Selection within the menus ...........................................35
6.4 Switching to the next menu point ..............................................35
7. SETUP MENU ..............................................................36
A Mounting orientation of the MICROBEAST .......................................37
B Swashplate servo frequency ....................................................38
C Tail servo center position pulse length ..........................................40
D Tail servo frequency ............................................................41
E Setting the Tail rotor endpoint ..................................................43
F Setting the Tail sensor direction .................................................45
G Adjusting the swashplate servo centering .......................................47
H Swashplate mixer ..............................................................49