User Manual
36
7. SETUp MENU
Before the rst ight the MICROBEAST has to be adjusted to your helicopter and the used components.
When the MICROBEAST shows that the system is ready, press and hold the button down, the menu LED next
to menu point A will begin to ash and then after a while will be steady on. Now and only now you can
release the button. You just entered the setup menu in menu point A.
To leave the setup menu you have to skip through all menu points by pressing the button several times.
After pushing the button at menu point N you will exit the setup menu and the system is ready for
operation again. None of the LEDs A - N are glowing anymore (see chapter 6).
If there is no stick or button input for 4 minutes, while being in the setup menu, the MICROBEAST
will exit the menu automatically. (This will not happen during setup points D, G, I and J to give you
enough time to adjust the mechanical setup of your helicopter).
Factory Reset:
To reset the MICROBEAST to factory settings, you can, at any setup menu point, push down the button for at
least 10 seconds until the LEDs A - N and J quickly blink one after the other to conrm the reset.
Please note that any previous conguration is now deleted. Do not attempt to y the helicopter without
doing the complete setup procedure again otherwise you will crash your helicopter. Please also note that all
servo settings are lost, therefore you should unplug the servos and remove the servo horns before resetting the
MICROBEAST.
The receiver type settings (see chapter 5) are not aected by the reset!
Conversely, if you change any settings in receiver type, the setup menu or parameter menu are not aected.
However, you have to redo the receiver-specic settings (channel assignment and fail-safe, see sections 5.2 to
5.3).