User Manual

If the Status-LED stays red, it means that there is no valid remote control signal available. In this

case, a channel assignment is impossible! If the Status-LED doesn’t turn blue after a few seconds,

check if the receiver is properly bound to the transmitter (bind already done successfully?) and

that a receiver of the correct type is selected in receiver menu point A. If a wrong receiver type has

been selected, switch o the power and re start the receiver type procedure.

By pressing the button at receiver menu point H the menu LED jumps directly to receiver menu

point N.

Move pitch stick

Move aileron stick

Push button

shortly

Push button

shortly

(Learning of subsequent

channels according to

table in section 5.2.2)

LED B ashing

Status-LED: blue

LED C ashing

Status-LED: blue

Status-LED: ashing blue

Learning of

pitch channel

Learning of

Aileron channel

Fig. 13