User Manual
28
5.2.2 Teaching of customized channel order
If you need a customized channel order, please rst prepare (if not already done) your transmitter as
described in section 3.2 .
Additionally, make sure (for example, using the servo monitor of your transmitter) that each control
function of your transmitter activates one and only one channel. This can be tricky especially for
throttle/pitch functions which are usually coupled by a mixer in the transmitter. In this case set the throttle
channel quiet by using for example the throttle hold switch or provide a at throttle curve so that the pitch
stick actually controls only the channel for the pitch servo, but for the later, keep the possibility to control
also the throttle channel by ipping a switch for example.
In the following 7 menu points B - H, you can assign dierent functions by simply actuating the appropriate
channel function on your transmitter. A blue ash of the Status-LED indicates that a channel has been
detected. It does not matter how far or in what direction you move the stick or in what position the stick/
switch was. Note the channel value itself is not important, but the change of this value is. It is therefore
important that only the requested function is activated and not by accident several simultaneously.
Otherwise, the MICROBEAST may not recognize the allocated channel correctly.
Release button
Hold button
a long time
LED B lights
Status-LED: blue
LED N lights
Status-LED is ashing
red / blue
Menu point B Menu point N
(Failsafe setting)
Loading of
standard channel
assignment
Fig. 12