User Manual

27
SRXL
BEASTRX Multiplex
transmitter channel
assignment
function function
channel 1 aileron aileron
channel 2 elevator elevator
channel 3 throttle (CH5) rudder
channel 4 rudder pitch
channel 5 tail gyro gain throttle (CH5)
channel 6 pitch tail gyro gain
channel 7 auxiliary (CH6) auxiliary (CH6)
Note: If the selected receiver type is “standard” another channel assignment is not necessary and
not provided since the allocation takes place by appropriate insertion of the cables into the
“Standard” receiver. Therefore menu points B to N are not accessible and the MICROBEAST jumps
after the brief press at menu point A to the end of the receiver menu (all menu LEDs ashing).
Power o the unit now and proceed as described in chapter 6.
If you are on receiver menu point B, please wait until the Status-LED lights blue.
If the Status-LED stays red, it means that there is no valid remote control signal available. A channel
assignment in this case is impossible! If the Status-LED doesn’t turn blue after a few seconds, check if the
receiver is properly bound to the transmitter (bind already done successfully?) and that a receiver of
the correct type is selected in receiver menu point A. If a wrong receiver type has been selected,
switch o the power and restart the receiver type setup procedure.
To load the selected standard channel assignment (see above tables), hold the button down for sever-
al seconds. The menu LED will immediately jump to receiver menu point N. In addition, you can also
load the default settings by pushing the button for several seconds in any of the points from C to H.
This will erase all previously made individual channel assignments.