User Manual

25
Then press the button, but only briey, to save the setup and switch to receiver menu point B.
If you have already briey pressed the button by mistake and it did not change the receiver type but switch
to menu point B, switch o the power and repeat the above procedure.
Programming example - operation with a Futaba® S-Bus receiver:
Hold the button down
Release button
Release button
Release button
Turn Power
supply ON
Keep button
pushed
a long time
Keep button
pushed
a long time
push button
shortly
LED A: ashing
Status-LED: OFF =
Standard receiver
LED A: ashing
Status-LED: ashing red =
Futaba® S-Bus receiver
LED A: ashing
Status-LED: purple =
Spektrum® receiver
LED B: ashing
Status-LED: blue
as soon as signal is valid
Menu Point A
Menu Point B
Fig. 11
convention: LED lights: LED is ashing:
Note: If selected receiver type is “Standard” the set up is now complete and by briey pushing the
button you will jump directly to the end of adjustment procedure (all menu LEDs are ashing).
Switch o the power supply now.
Another channel assignment is not necessary and not provided since the allocation takes place by
appropriate insertion of the cables into the “standard” receiver. So you can directly proceed with
chapter 6.