User Manual

23
4.2.4 Connection of single line receiver with additinal servos connectors (e.g. S-Bus, SRXL)
Connect the receiver to the MICROBEAST with one of the supplied regular 3-wire cables. Plug the cable into
the MICROBEAST input [DI1] and the other to the receiver to the output [S. BUS] or [B | D] ® for Multiplex.
Please make sure that the connectors are plugged in with the correct polarity. Be careful, since the supplied
cable is designed to be used universally, and the Futaba® polarity protection tab missing. On the MICROBEAST,
the orange signal wire must be close to the top cover.
This description also applies to other single line receiver with additinal servos connectors (e.g. SRXL
receivers (Multiplex or BEASTRX)):
Fig. 10
Top
Elevator servo
Aileron servo
Aileron/pitch servo
Tailservo
Power supply
e.g. Futaba® S-BUS
Receiver
Bat
S-BUS
Additional channel
Throttle servo/ESC
and power supply)
We recommend to directly connect speed controller and additional functions to the receiver to use the Failsafe /
Hold functions of the remote control system (see 4.2.1). But you can also CH5 and CH6 on the MICROBEAST for
these functions!