User Manual

15
4.1 Connection of a standard receiver
4.1.1 Flybarless usage
Now plug the receiver cables for aileron, elevator, pitch, rudder and tail gain between the MICROBEAST
and the receiver. To nd out the channel assignments of your remote control receiver, please refer to
the user manual of your transmitter or contact its manufacturer.
To connect elevator and aileron, use the plain 3-wire cables that transmit the control signal in
addition to the power supply from the receiver to the MICROBEAST.
Pitch (red), tail (orange) and gain (brown) have only one lead for the control signal on the receiver side, and
are connected to the MICROBEAST on the combined connector. Please ensure these plugs are connected
correctly to the receiver. Although the cable color is dierent, all three wires are signal lines, which go to the
usual orange, yellow or white side! + and - remain open on theses channels.
Please respect the polarities for the plugs going to the MICROBEAST. The orange line on the MICROBEAST
must always be on the top and the brown on the bottom. Also be sure when inserting the connectors
not to accidentally plug them into the space next to the pins or vertically oset by one pin.
Other wires such as throttle servo, ESC or power supplies are connected as usual to the remote control
receiver.
Elevator
Aileron
Elevator servo
Aileron servo 1
Aileron servo 2 / Pitch
Tail servo
Rudder (orange)
Pitch (red)
Tail Gain
(brown)
receiver outputs
Fig. 4
Top