User Manual

Managing Robots
Servi Plus User Manual |
36
2.
If the wheel cover is separated from the robot main body, open the
cover as shown in the gure below.
3.
After cleaning, put the wheel cover back on and turn it to the right as
shown in the image in 1 above. The center line should run parallel the
edges of the robot main body.
Transportation/Storage
The below instructions describes how to properly transport and store the
robot.
○
Transportation Method
y
To move the robot indoors, you can stand in front of or behind the
robot and push it to the desired position.
y
A robot is paused when the screen is touched while on the move.
Pause and then move the robot to a desired place.
Caution
y
Do not grab, move, or drag the tray.
y
While the robot is moving, do not drag it or block it in a hurry to stop it.
y
Be careful when moving the robot is negotiating a slide.
y
Do not lift and move the robot wheels that they are off the ground.
y
For external/long transportation, use specialized transport vehicles
and equipment with the robot powered off.
○
Storage Instructions
When storing the robot, charge the battery and store it by referring to the
follows.
y
The optimal storage temperature range for the robot is 50 – 95 ˚F
(10 – 35 ˚C), and the optimal humidity range is 10 – 80%.
y
When storing the robot wrapped in packing material, include some
moisture absorbents.
y
When storing the robot for extended periods, make sure to take
necessary safety measures to prevent the risk of tipping over.