User Manual

Servi Plus User Manual |
34
Managing Robots
Installation
○
Silicone Pad
1.
For the top tray pads, insert the display part rst, and then align them
by inserting them on both sides. (Refer to Figure 1)
2.
When assembling the center tray pad, make sure that the pads do not
play to touch the inner surface of the robot structure.
y
If the tray pad is not installed properly, it may affect the weight
sensor mounted at the edge of the tray and cause robot
malfunction. (Refer to Figure 2)
3.
Place the pad on the bottom tray according to the shape of the tray.
4.
After installing the pads, reset the weight sensor. (Refer to
Page 30)
Caution
When inserting the pads again after initial installation or cleaning, make
sure that the pads are properly inserted into the tray.
<Figure 1> <Figure 2>
Maintenance
○
Exterior
Lightly wipe the exterior surfaces of the robot with a dry cloth or cloth.
Keep the robot's cameras and sensors clean as dirt and debris can affect
operation.
Caution
Do not use alcohol, acidic solutions, or strong chemical cleaners. The robot
surface may be damaged.