User's Manual

Winch Box Components (3A) (no mention of cables)
• Fairlead at front of winch: consists of 2 vertical rollers and two horizontal rollers. The horizontal
rollers are mounted behind the vertical rollers.
• Loadspars on the left and right.
• Covers at the top and bottom.
• Carrying handle in back of winch.
• Motor cable and connectors exit form back of winch.
• Comes with 2mm ultra-high molecular weight polyethylene winch line.
Winch Box Bolts – Service and Maintenance (3B)
• Motor cable(s) should be disconnected from Ebox during maintenance.
• Metric tools are used to assemble the winch: 6mm allen key used for fairlead components, 5mm
allen key used for hardware in the loadspar
• If access to the spool is required, remove bolts as shown in instructional video to hinge open the
top cover.
Winch Box Cover Bolts (3C)
• Tighten bolts on the right-side cover first when reassembling.
• Tighten to tech-tight – bolt head should contact feature in loadspar, then tighten one-quarter
turn.
o Repeat on left-side of cover to fully, properly secure the cover.
Ebox External Features (6A)
• Handle – for carrying/transportation located on front of Ebox.
• Latches – secures lid; one on each side of handle located on front of Ebox.
• SMA connector – connects/mounts antenna located on front of Ebox next to left-side latch.
• Heat sink - on the bottom on Ebox.
• Motor connectors with rubber caps – located on right-side of Ebox.
o Keep caps on when not in use to prevent water/sand egress.
• Power Button – turns Ebox on and off located on right-side of Ebox.
o Ebox is powered when this button is depressed and Green LED is on.
Ebox Opening & Closing (6B)
• Do not leave lid open during operation.
• Only open lid to adjust speed setting and access battery.
• Push down on grey portion of latches to release latch and swing up to open lid.