User's Manual

Handle Power & Throttle (2C)
• Push the silver power button to turn on. The button is located above the microUSB and between
the LEDs. You should hear an audible click when actuated and the LEDs will turn on when the
handle is on. They LEDs turn off when the handle is turned off.
• When the Red LED is on the handle is powered.
• The Green LED indicates throttle input.
o There’s about 10% of dead-play in the throttle for safety.
o LED gets brighter with increasing throttle input. LED dims when throttle input is
reduced.
Adjusting Handle Ends (2D)
• Adjusting the handle ends allows for general handle orientation under tension.
o Adjustments should be done symmetrically.
o Left side handle end should be snug to plug.
• Loosen hardware with 2mm allen key.
o Do not use a rounded allen key.
• After adjusting the handle ends tighten the hardware until contact is made – then turn
hardware one half-rotation to complete the adjustment.
Handle Charging (2E)
• Charging should only be done using the provided cable and charging brick.
o 5V 1A charging brick and cable are provided.
o Charging using the provided cable via a computer or laptop is allowed.
o Charging time is about 1.5hrs.
o Handle should remain off while charging.
• Ensure the microUSB port is completely dry before attempting charging.
o Rice can be used to quickly remove all moisture from end of handle.
• Once the cable is connected and charging is initiated an Orange LED will turn on.
o Charging LED is to the right of the Power Button at handle end.
• Once the handle is fully charged a Blue LED will turn on.
o Charged LED if to the left of the Power Button at end of handle.
• If any LEDs turn on during charging that aren’t Blue or Orange, something is wrong, contact
Motowinch.
o Conversely if no LEDs turn on during charging, something is wrong, contact Motowinch.
• A fully charged handle provides about 8hrs of run time.