Operation Manual


TROUBLESHOOTING
1. Ifthepowersupplyindicatorisoffandthelaserdoesn'twork,pleasecheckthepowersupplyandthe
inputvoltage.
2. InStand‐Aloneoperation,ifthepowersupplyindicatorisONandsoundactiveindicatorisOFF,butthe
laserdoesn'twork.
A. Becausesoundistoosmallandcannotactivatelaserrunning,pleaseincreasethemusicvolumeor
increaseaudiosensitivityonrearpanel.
B. Pleasecheckifunithasbeensetupinslavemode,orDMXmode.
3. InMaster‐Slaveoperation,slaveunitsdon'tfunction,pleasecheckasbelow.
A. Makesurethere'sonlyonemasterinthechain,andtheothersaresetinslavemode.
B. MakesuretocontroltheunitswithDMXcontroller.
C. MakesuretouseagoodqualitypowercableandXLRconnector.
4. In DMX mode operation,the laseris OFF and the DMX signal indicator is unlighted, please check as
below
A. MakesureDIPswitch#1and#10areON.
B. MakesuretohaveagoodXLRconnection.
5. In DMX operation, the unit can’t be controlled by the DMX console, but the DMX signal indicator is
flashing,pleasemakesuretheDMXconsoleandunithavethesamechannel.
6. Iftheoutputbeamdirectionaboveisunusual,pleaserestarttheunit.
7. Iftheunitisfail,pleaseturnofftheunit,andthenturnonagainafter5minutes.

Aftertryingtheabovesolutionyoustillcannotsortoutthe problem,pleasecontactyourdealerorour
companyforservice.