Operation Manual



Attention Laser will be output from laser aperture in 5 seconds after the unit is powered on.
MAINTENANCE
z Make sure the area below the installation place is free from unwanted persons during servicing
z Switch off the fixture, unplug the mains cable and wait until the unit has been cooled down.
z Housings, fixations and installations spots( ceiling, truss, suspensions) should be totally free from any deformation
z The mains cables must be in impeccable condition and should be replaced immediately when even a small problem is detected
z In order to protect the fixture from overheat the cooling fans (if any) and ventilation openings should be cleaned monthly.
z The cleaning of aperture glass and scanner mirrors must be carried out periodically to optimize light output. Cleaning frequency
depends on the environment in which the fixture operates: damp. smoky or particularly dirty surroundings can cause greater
accumulation of dirt on the unit’s optics
1) Clean with a soft cloth using normal glass cleaning products.
2) Always dry the parts carefully.
3) Clean the Aperture glass at least once every 30 days
z The interior of the fixture should be cleaned annually using a vacuum cleaner or air-jet.



Specifications subject to change without prior notice.
The availability of particular products may vary by region. Please check with the dealer.




ATTENTION: We strongly recommend internal cleaning to be carried
out by qualified worker!