Specifications

RST-100 INSTALLATION AND CONFIGURATION MANUAL

Error codes

The list of error codes are:

Error Code

Error Description

1 The non volatile memory on the RST was invalid on power-

up. Parameters are defaults.

2 Some sort of SMS system error. Usually unimportant. SMS

error code as PIN.

3 An equipment error reported from the LBT. ME error code as

PIN.

4 Over-temperature alarm from RJ11 line interface.

5 ROM checksum error on RST firmware. Continued correct

operation in doubt.

6 The RST has had to hardware reset the LBT due to a lack of

response. Can occur if LBT serial port locks up.

7 Short Burst Data sending error. MO error as PIN.

8 Short Burst Data reception error. MT error as PIN.

9 Battery Flat/Fault error.