User manual
24
Bluetooth® Data Conguration
A computer or data host with Bluetooth® data can be connected wire-
less with IntelliDOCK. To congure (pair) to a Bluetooth® serial data
device:
1. Power up the IntelliDOCK system, to ready state.
2. Turn OFF any other Bluetooth Audio or Data devices in range
nearby.
3. Discovery Mode: Press and hold for 5 secs the Bluetooth®
button on the cradle, until the cradle sounds a double (2) beeps.
The LED will then ash Blue and Orange until the data device is
paired.
4. Instruct the data-device / computer to search for a new device
to pair with. The IntelliDOCK will accept pin codes 0000 and
1234. You can change these defaul pin codes via the IntelliDOCK
management system (PDMS).
5. Once the devices are successfully paired, the Bluetooth® LED on
the cradle will start slow ashing Blue, to indicate data connection
available.
6. Bluetooth® can be turned ON with a single press, and OFF by
press and hold for 2 secs the Bluetooth® button on the cradle.
The cradle will sound a single (1) beep when turning off.
NOTE:
To clear all paired devices from IntelliDOCK memory, Press and
hold for 10 secs the Bluetooth® button on the cradle, until the
cradlesoundsatriple(3)beeps.