User manual

22
Privacy Handset (optional accessory)
The IntelliDOCK provides a 4-pole 3.5mm audio socket on the rear cable
loom, for connection to the Beam Privacy Handset. This provides local
handset function, conveniently mounted next to the IntelliDOCK cradle.
1. The Privacy Handset Kit (purchased/ordered separately) contains
a mounting bracket, space plate, and fasteners.
2. Mount the handset cup to the mounting plate.
3. Mount the spacer plate and the mounting bracket to the rear of the
IntelliDOCK, by using the longer screws provided with the kit. The
original RAM arm-bracket plate is also re-installed behind these
plates.
4. Plug the Privacy Handset 4-pole connector into the rear
cable loom. (Please use suitable electrical tape and/or strain relief
clamps where required to ensure reliable connection)
Privacy Handset mode is enabled when the handset is removed from
the cup. Please ensure to re-dock the Privacy Handset when not in use.
Preliminary Testing
Prepare the Iridium 9555 Handset
1. Ensure that the 9555 Handset is running with the required
compatible rmware.
2. Remove the rubber plug / bung / grommet from the rear of the 9555
Handset, to reveal the antenna socket hole.
Connect Power
Once all the components are installed, apply appropriate fuses, and
apply power to the cradle.
1. After a few seconds the cradle LEDs will start to operate.
2. Once the cradle appears to be powering okay, dock the 9555
Handset (refer to section: “Docking & undocking your 9555
handset”)
3. Please wait for the Handset to automatically power cycle and then
progress to nd registration.