User manual

Bluetooth®Configuration(Optional)

SatDOCK 9555 has an in-built Bluetooth® module for voice

and data connectivity.

Bluetooth® Headset Conguration

To congure/pair to a Bluetooth® headset (audio) device:

1. Power up the SatDOCK 9555 cradle.

2. Press and hold the Bluetooth® button on the cradle for 5

seconds, until the cradle sounds a double (2) beep. The

Bluetooth® LED will then ash BLUE and ORANGE.

3. Hold the headset (device) button(s) to enter the pairing

mode (please refer to the headset user manual).

4. Once the devices are successfully paired, the Bluetooth®

LED on the cradle will change to BLUE (half intensity).

5. Bluetooth® can be turned ON with a single press, and

OFF by pressing and holding the Bluetooth® button for 2

seconds on the cradle. The cradle will sound a single (1)

beep when turning off. Once paired, the SatDOCK 9555

will automatically connect to this device every time the

SatDOCK 9555 powers up.

You may repeat this process to pair more than one headset (up

to 17 total devices including data connections) – ensure only one

device is switched on during subsequent pairing conguration.

Tracking&AlertConfiguration(optional)

Tracking & Alert requires the installation of a GPS antenna,

and setup of the tracking and/or alerting messages.

Please refer to the SDMS software to enable and congure

Tracking & Alert.

NOTE:

Any time there is reference to the Bluetooth® button or the

Bluetooth® LED it is referring to the button shown below

which is the same button on the front of the SatDOCK

9555.

NOTE:

If the Beam alarm loop is going to be used with an external

button, remember to enable this external loop in the SDMS

settings. Once enabled, the loop will be armed and activated

with an open-loop condition.

To avoid false triggering, be sure to have the normally closed

button wired into the alert loop, before applying power.