User manual

24
3. Connect the BLACK wire to the negative terminal of the
battery (10A fuse recommended) or the vehicle chassis (if
negatively grounded chassis).
4. Connect the RED wire to the positive terminal of the battery.
It is recommended to add a 3A fuse between them.
5. Connect the YELLOW wire to the vehicle accessory
power. If the accessory power is unavailable, this may be
connected to a vehicle ignition voltage. It is recommended
to add a 1A fuse between them. The accessory wire
enables the SatDOCK 9555 to turn on and off as the
vehicle key is enabled or disabled. If this function is not
required, the YELLOW wire MUST be connected to the
RED wire.
Wiring for a Marine Application
When installed in a marine application using the DC power cable,
the YELLOW wire can be wired to a suitable panel switch which
will allow the SatDOCK 9555 to be turned off when not in use.
RED (+) Vin 9 to 32VDC
BLACK (-) OV Power Ground
YELLOW
(IGN) Ignition / Accessory
To Battery Positive Terminal
(3A Fuse recommended)
To Negative Terminal or chassis
To ACC switched power
(1A Fuse recommended)