Technical data

9
2.4. Stand
The frame is the support structure of the BEAM Commercial vacuum unit. Its adjustable support feet
allow the vacuum unit to be levelled even on irregular surfaces.
2.5. Dust container
The dust container has a collection capacity of 90 liters. The container has a dust collection bag for
the disposal of dust. The level of dust in the dust container must be checked approximately every two
months, depending on the conditions of use.
The handle is used to open the dust container, also making the cartridge lter accessible.
The dust container also has a low-pressure pipe that warrants the retention of the dust collection bag.
2.6. Central section
The central section contains the main control components of the BEAM Commercial central vacuum
unit, as follows:
• Electrical control panel
- Inverter
- Main switch
- Self-cleaning timer (BC126A and BC238A)
- Electronics board for control of the lter self-cleaning function (BC126A and BC238A)
• Cartridge lter
• Pressure transducer for regulation of the operating suction pressure
• Compressor for lter self-cleaning function (BC126A and BC238A)
• Compressed air tank for lter self-cleaning function (BC126A and BC238A)
• Solenoid valve for lter self-cleaning function (BC126A and BC238A)
• Suction inlet pipe Ø63 mm
2.7. Top section
The top section contains the turbine, and is soundproofed to make operation of the BEAM
Commercial central vacuum unit as silent as possible. The top section is tted with a Ø63 mm air
exhaust pipe.
2.8. Safety and hazard stickers
Figure 4 on the following page shows the points where stickers with recommendations, hazard
warnings and prohibitions are applied, helping to make the BEAM Commercial central vacuum unit
safer to use.