User's Manual
%($02FHDQD,QVWDOODWLRQ8VHU0DQXDO
%'#0#LNN(70%6+10-';2#&
Location Button
mode
Action LED/Sound
Mute press
on/o
In a call:
Mute the microphone (uplink) on the privacy handset.
LED turns RED - muted
LED turns OFF - not muted
LED ashing Yellow - RJ11/POTS in use
OR
Up/Down In a call:
Increase/decrease volume on speakerphone or privacy handset.
Audio will sound louder/quieter with each press.
Out of call:
Increase/decrease volume of incoming ring tone on the
speakerphone.
A beep will sound indicating the increased/decreased ring tone volume
Brightness
dual button
simultaneous
press
(1 second)
Out of call:
Enter LED brightness change mode. Press UP and DOWN arrows
to vary intensity. Mode will automatically exit after 5 seconds after
the last button press.
All LED’s will change to WHITE and a single beep will sound when entering brightness
change mode.
A short double beep will sound when exiting change mode.
Speakerphone
press ON/OFF
In a call:
Terminate call if speakerphone mode is active
Activate speakerphone mode if Privacy Handset mode is active.
LED turns GREEN - speakerphone mode active
LED turns OFF - speakerphone mode not active
Out of call:
Answer inbound call in speakerphone mode
Instant
Message (IM)*
When Instant Message enabled/congured a 0->3 second press
triggers an instant message.
A 7 second press will clear the instant message.
When Instant Message disabled no functionality.
IM functionality disabled – no backlight, no colour
IM functionality enabled but not triggered – LED should be Green
IM button pressed LED changes from GREEN to solid RED (a beep will sound when triggered)
Once rst emergency message has been sent LED changes from solid RED to ashing RED
Once remote acknowledgement of instant message, LED changes from ashing RED to slow
ashing YELLOW.
If audio tones for instant message is enabled:
A beep will sound from the buzzer when the Instant Message is triggered
A double beep will sound from the buzzer when the Instant Message is cleared
Tracking* When tracking enabled a momentary press results in a tracking
message being queued for sending.
When tracking disabled no functionality.
LED On and Red - tracking enabled and NO GPS x
LED on and Green - tracking enabled and GPS x
LED Flashing Green - track button has been pressed (beep will sound from the buzzer). Will stay
ashing for 5 seconds to indicate message sending. OR Transceiver upgrade mode active.
LED Flashing Red - rmware upgrade mode active
*This action is optional, only when the Tracking Mode for your Oceana 800 is congured and activated.