User's Manual

%($02FHDQD,QVWDOODWLRQ8VHU0DQXDO

To manually send a tracking message of the
current location A. Apply a single press to
the track button. A single beep will sound (if
congured in the Falcon).
Activate instant message mode
Instant message mode can be activated by one
of the following two methods:
1. Press and hold the instant message button
for 2 seconds. A single beep will sound (if
congured in the Falcon).
2. If enabled by the Falcon, press and hold
the external instant message button
(optionally wired into the instant message
loop wires). Once triggered into the instant
message mode, the track LED turns RED.
The message then attempts to be sent.
The track LED will ash in RED when the
message is sent. (Rate: 1.5 sec o, 1.5sec
on, etc). The track LED will ash in YELLOW
when the message is acknowledged by a
remote host. (Rate: 1sec o, 4sec on, etc)
Clearing an instant message
To clear the instant message mode press and
hold the button for seven seconds. A single
beep will sound, and the LED will show
re-armed state (GREEN).
Data use
Ensure that you have installed the BEAM USB
driver – see section “Conguration settings ”
(shown on page 27).
The Oceana 800 terminal allows for circuit
switched data via the BEAM USB data port
that is presented when plugged into your PC.
Follow the normal procedures with your data
application to connect. Once connected, the
Call LED will be flashing YELLOW. Once the
circuit switched connection has ended, the
Call LED will turn off.
NOTE:
During a data connection, the RJ11/POTS handset
cannot make or receive voice calls. An unavailable
tone will be heard on the RJ11/POTS handset.
4#%-+0)#0&+056#06/'55#)'
Enable tracking & instant message
The tracking & instant message function
is NOT enabled by default and it has to be
congured using the Falcon software via the
mini-USB connection to the Oceana 800. Various
conguration options are available to the user in
Falcon. The message delivery method is also set
using the Falcon. Please refer to the Falcon user
guide for more details on how to congure and
enable the tracking & instant message function on
the Oceana 800 terminal.
Send tracking position
In order to send a tracking message, the
following conditions must be fullled.
1. The GPS receiver has acquired enough
satellite signals and navigational data to
calculate a positional solution (x).
2. The Oceana 800 is registered with the
GSPS network.
3. Tracking is congured and enabled via
the Falcon. The track LED will stay o if the
tracking function is disabled. It will turn
solid GREEN if all of the above conditions are
satised. Otherwise, it will ash in GREEN if
the tracking function is enabled but no GPS
x and/or GSPS registration has occured.