User's Manual


Mobile terminating
1. Answer the incoming call by pressing the
speakerphone button or the GREEN key on
the Oceana 800 keypad.
2. Once the call is in progress, the same options
are available as described in “Speakerphone
phone call – mobile originating”
3. Press the RED key on the Oceana 800
keypad to terminate the call.
Privacy handset use
mobile originating
1. Remove the privacy handset from its cup
2. Dial using the full Inmarsat dialing
sequence eg. 00 country code and
telephone number on the Oceana 800
keypad whilst docked. Press the GREEN
button to start the connection.
3. A message is displayed on the screen
display to indicate a call is in progress.
4. Once the call is connected, the STATUS LED
will ash to indicate a call is in progress.
5. Press the RED key on the Oceana 800
keypad or return the privacy handset to its
cup to terminate the call.
Options:
A. During a call, you may switch to
“speakerphone” mode by pressing the
speakerphone button on the terminal.
Return the privacy handset to its cup.
B. To return the call back to the privacy handset,
remove the privacy handset from its cup.
Mobile terminating
1. Answer the incoming call by un-cupping
the privacy handset from its cup.
2. Press the RED key on the Oceana 800
keypad or return the privacy handset to its
cup to terminate the call.
76'/1&'
Mute functionality
The mute function of the Oceana 800 allows the
user to mute the uplink microphone audio on
the privacy handset and/or internal handsfree
microphone.
1. During a call, press the mute button on
the front of the Oceana 800, a RED LED will
illuminate the mute button to conrm that
the uplink audio is muted.
2. To exit the mute mode, press the mute
button once.
EEf2*10'75'
Mobile originating
1. Lift the RJ11/POTS phone handset “OFF
HOOK” and listen for the dial tone. The call
LED will ash GREEN to indicate the RJ11/
POTS is in use.
2. Dial (using the full country codes) on the
RJ11/POTS telephone keypad.
3. Once the call is connected, the POTS Status
LED will ash to indicate a call is in progress.
4. Place the RJ11/POTS phone handset “ON
HOOK” to terminate the call.
Mobile terminating
1. The RJ11/POTS phone will sound its ringer.
2. Lift the RJ11/POTS phone handset “OFF
HOOK” to answer the call.
NOTE (default operation)
For mobile terminated calls, the call will remain
active for ~90 seconds even if the RJ11/POTS
phone is placed ON HOOK. To end the call
immediately, the other calling party must hang
up (ON HOOK) the call.