User's Manual

%($02FHDQD,QVWDOODWLRQ8VHU0DQXDO

.#%+0)81+%'%#..5
Speakerphone call use
Mobile originating
1. By default the Oceana 800 will start
all calls in speakerphone mode when
dialing on the keypad if RJ11 and privacy
handset remain on hook.
2. Dial using the full Inmarsat dialing sequence
eg. 00 country code and telephone number
on the keypad. Press the GREEN key
on the Oceana 800 keypad to start the
connection.
3. A message on the display will indicate the
call is progressing.
4. Once the call is connected, the STATUS LED
will ash to indicate a call is in progress.
5. To terminate the call, Press the RED key on
the Oceana 800 keypad.
Options:
A. During a call, you may take the privacy
handset out of its cup. This automatically
directs the call audio to the privacy handset.
To return the call back to “speakerphone” mode,
press the speakerphone button, then return the
privacy handset to its cup.
4#%-+0)n+056#06/'55#)'
%10(+)74#6+10j126+10#.k
It is optional to activate the tracking function
on your terminal. Please refer to the Falcon
software to enable this function.
Instant message can be enabled via the tracking
conguration. This option can be activated
through the below link as required.
www.beamcommunications.com/support/
oceana800
NOTE
If the BEAM alarm loop is going to be used
with an external button, remember to enable
this external loop in the Falcon settings. Once
enabled, the loop will be armed and activated
with an open-loop condition.
To avoid false triggering, be sure to have the
normally closed button wired into the instant
message loop, before applying power.
')+564#6+10
1. Turn ON power to the terminal. The
signal LED will start flashing RED.
2. Wait for the terminal to register to the
Inmarsat network and acquire GPS lock.
This may take up to 2 minutes.
3. Inmarsat will be displayed in the top left of
the screen once registration has occurred.
4. Ensure you have at least two bars of
signal strength.
5. The Status LED will then be solid GREEN
or YELLOW and the terminal is now
ready for calls.
NOTE
If your SIM has the PIN enabled, see section
“SIM PIN use” (page 28) to enter PIN, or to
permanently disable PIN. The terminal will not
register if PIN is required.