User's Manual

%($02FHDQD,QVWDOODWLRQ8VHU0DQXDO

056#..#6+10241%'&74'
056#..+0)6*'%'#0#LNN
The following sections detail the installation of
the Oceana 800.
1. Install the antenna
2. SIM installation
3. (A) Wall mounting orientation
(B) Desk mounting orientation
4. Privacy handset and mounting cup
5. Rear connector bay
6. Connect POTS/RJ11 interface
7. Auxiliary connection (optional)
8. (A) Ring alert / audio system mute
(B) Instant message loop
9. USB port connection (lower side)
10. Connect power to Oceana 800
11. Cable routing
12. Water resistant IP54 rating
13. Conguration settings
Ek056#..6*'#06'00#
To connect the Oceana 800 to the antenna,
requires the use of certied satellite and GPS
antenna cables. These purpose built cables
are approved by BEAM to manage the power
requirements for the antenna system. The full list
of approved cables can be found at
www.beamcommunications.com/oceana800
1. Refer to the antenna installation guide
for antenna mounting and location
requirements.
2. Run the antenna cables from the Oceana
800 to the antenna.
3. Connect the antenna cable labelled “GPS” to
the SMA antenna connector labelled “GPS”.
4. Connect the antenna cable labelled “Inmarsat”
to the SMA antenna connector labelled “ISAT”.
5. Connect the GPS-SMA (Female) cable end
to the Oceana 800’s SMA connector.
6. Connect the TNC (Female) antenna
cable end to the Oceana 800’s satellite
connector.
Antenna connection diagram for OC800
Maritime antenna (active)
65
4
3
TNC
SMA
SMA
SMA
Satellite
Antenna
Cable
GPS
Antenna
Cable