User's Manual
Terra400 & Oceana400 - Installation & User Manual
23
Operation
Registration
1. Turn on power to the terminal. The
Signal LED will start flashing RED.
2. Wait for the terminal to acquire GPS lock
and register to the Inmarsat network.
This may take up to 2 minutes.
3. The Signal LED will then be solid GREEN or
YELLOW and the terminal is ready for calls.
NOTE: If your SIM has the PIN enabled, see section
“SIM PIN use” to enter PIN, or to permanently disable
PIN. The terminal will not register if PIN is required.
RJ11/POTS Phone Use
Mobile Originating
1. Lift the RJ11/POTS phone handset
“OFFHOOK” and listen for the dial tone.
The call LED will ash GREEN to indicate
the RJ11/POTS is in use.
2. Dial (using the full country codes) on the
RJ11/POTS telephone keypad.
3. Once the call is connected, the POTS STATUS
LED will ash to indicate a call is in progress.
4. Place the RJ11/POTS phone handset “ON
HOOK” to terminate the call.
Mobile Terminating
1. The RJ11/POTS phone will sound its ringer.
2. Lift the RJ11/POTS phone handset
“OFFHOOK” to answer the call.
NOTE: (Default Operation)
For mobile Terminated calls, the call will remain
active for ~90 seconds even if the RJ11/POTS
phone is placed ONHOOK. To end the call
immediately, the other calling party must hang
up (ONHOOK) the call.
Data Use
Ensure that you have installed the Beam USB
driver – see section “Conguration Settings ”
(shown on page 21).
The TR400/OC400 terminal allows for circuit
switched data via the Beam USB data port
that is presented when plugged into your PC.
Follow the normal procedures with your data
application to connect. Once connected, the
Call LED will be flashing YELLOW. Once the
circuit switched connection has ended, the
Call LED will turn off.
NOTE: During a Data connection, the RJ11/POTS
handset cannot make or receive voice calls. An
unavailable tone will be heard on the RJ11/
POTS handset.