User's Manual

Terra400 & Oceana400 - Installation & User Manual
21
8) Configuration Settings
The TR400/OC400 terminal is ready for you to
make voice calls as soon as it is registered. But
if required, your TR400/OC400 terminal allows
advanced conguration to customise operation.
This rst step for conguration is to install the
Beam USB driver.
USB Driver Installation
TR400/OC400 Terminal USB data port requires
an interface driver to be installed on the
user’s computer prior to undertaking data
communication. This driver supports the
following operating systems:
Windows XP (SP3 or above) & Windows 7
The Windows Driver for the TR400/OC400
is contained in the Falcon application
download. If required separatly, the USB
driver can be downloaded from:
http://www.beamcommunications.com/support
Conguration using Beam Falcon application
The Falcon application can be downloaded from:
http://www.beamcommunications.com/support
Follow the instructions in the downloaded
application to install. Launch the Falcon
application which is used to connect to the
terminal via the USB port. You can then use the
application for a range of options such as:
• View the status of the terminal (signal,
temperature, input voltage)
• rmware maintenance
• congure dierent POTS/RJ11 settings
• congure power modes
• SIM card PIN/PUK handling