User's Manual

BETA – IsatDock Overview Beam Communications
STRICTLY CONFIDENTIAL
Page 24 of 29
7. Placing a call – Inbuilt speakerphone and Privacy handset
1. Dock the IsatPhone into the docking station
2. Wait for the docking station to synchronize with the IsatPhone. If the IsatPhone Pro was
inserted in the OFF state it can take approximately 1minute for the handset to turn ON and
synchronize with the docking station.
3. Check that the status LED is solid green
4. Dial the destination number on the IsatPhone Pro’s keypad and place the call
5. By default the IsatDock Pro and Marine will start all calls in speakerphone mode. If you wish
to switch to using the Privacy handset you can do so by taking the privacy handset off-hook.
6. Terminate the call by returning the Privacy Handset back to ON-Hook or by pressing the
‘speakerphone’ button. You can terminate all calls by pressing the red button on the
IsatPhone Pro handset.
8. Placing a call – POTS/RJ11 Interface
1. Dock the IsatPhone into the docking station
2. Wait for the docking station to synchronize with the IsatPhone. If the IsatPhone Pro was
inserted in the OFF state it can take approximately 1minute for the handset to turn ON and
synchronize with the docking station.
3. Check that the status LED is solid green
4. Lift the handset of the POT’s phone. You should hear a constant tone
5. Dial the destination number. Call processing is disabled by default, therefore dial the
destination in international format.
Eg 00 61 3 9560 9055
00 International dial prefix
61 Australia dialing code
3 95609055 National prefix and destination number
6. Once the call has connected you can terminate the call at anytime by placing the POT’s
handset back ON-HOOK.
9. Adjusting Volume