User's Manual

BETA – IsatDock Overview Beam Communications
STRICTLY CONFIDENTIAL
Page 15 of 29
4.3. PRO/MARINE – Privacy Handset
There are two options for the privacy handset mounting cup depending upon the type of docking
station and the mounting orientation of the docking station. One mounting cup has a sprung upper
section while the second is a single molded piece with a reversible retention clip.
The three options are shown below in Figure 13.
Option A shows a horizontal desk mounted situation. The ‘springless’ cup is fitted to the docking
station with the mounting clip in a ‘flush’ position.
Option B shows how the mounting clip can be slid out and reversed, producing a protruding point
that the Privacy handset rests upon. For a wall mounted docking station this retains the privacy
handset and the springless cup has enough height to allow the handset to rise up off the clip and
out of the mounting cup.
Option C. In harsh environments, the Privacy handset is actively retained in the mounting cup.
This is achieved by using the ‘sprung’ mounting cup. To remove the handset from the cup, the
phone is lifted up against the pressure of the spring until it clears the lower mounting pip and can be
removed from the docking station (see Figure 15)
A - Desk Mounted B - Wall Mounted (Stable Conditions) C - Wall Mounted (Captive)
Figure 13 – Mounting Cup options
Figure 14 – Mounting Cup Clip