User's Manual

BETA – IsatDock Drive/Lite Overview Beam Communications
STRICTLY CONFIDENTIAL
Page 21 of 25
7. Placing a call – Inbuilt speakerphone (Drive) and Privacy handset (Lite
& Drive)
1. Dock the IsatPhone into the docking station
2. Wait for the docking station to synchronize with the IsatPhone. If the IsatPhone Pro was
inserted in the OFF state it can take approximately 1minute for the handset to turn ON and
synchronize with the docking station.
3. Check that the status LED is solid green
4. Dial the destination number on the IsatPhone Pro’s keypad and place the call
5. By default the IsatDock Drive will start all calls in speakerphone mode. If you wish to switch
to using the Privacy handset you can do so by taking the privacy handset off-hook.
6. Terminate the call by returning the Privacy Handset back to ON-Hook or by pressing the red
button on the IsatPhone Pro handset.
8. Adjusting Volume
NOTE: The IsatPhone Pro handset has its own volume controls for both incoming call
ringing and in-call audio levels. It is recommended that you set the IsatPhone Pro to
maximum volume and use the docking station to reduce the volume if required.
You can raise and lower the volume of the docking station by pressing the UP/DOWN arrows.
Not in a call – Idle state : IsatDock Drive ONLY
When in the idle state, pressing the up/down buttons will adjust the incoming call ring volume
In call
When in a call pressing the up/down buttons will adjust the call volume.