User's Manual

BETA – IsatDock Drive/Lite Overview Beam Communications
STRICTLY CONFIDENTIAL
Page 16 of 25
Electrical Interfaces
5.1. DRIVE – Main Loom
When the IsatDock DRIVE is attached to the RAM mount, the
main interface loom exits from the rear of the plastics as shown
in Figure 8. Tabled below are each of the connections found at
the end of this loom.
Figure 8 – IsatDock DRIVE main loom
INTERFACE DESCRIPTION CONNECTOR
DC Input
DC input to the dock Micro-Fit3.0 Dual Row 4Way
inline plug
Accessory
Detects when the vehicle ignition in on
GPS Antenna
Connection point for the external GPS
antenna.
SMA (F) inline connector
GSPS Antenna
Connection point for the external GSPS
antenna.
TNC (F) inline connector
Alert Loop
Two wire normally closed (NC) alarm alert
loop, for connecting to remotely located
Duress Button(s)
24AWG wire ends
Horn Dock output to a system input or relay
drive which can power the vehicle horn
24AWG wire end
Radio Mute Output to interface to an existing
entertainment system.
24AWG wire end
Ext Speaker Output to an external speaker
Micro-Fit3.0 single Row 2Way
inline plug
Ext Microphone Input from an external microphone
Micro-Fit3.0 Dual Row 2Way
inline plug