User Manual

7.8 Ethernet
The board comes with a single 10/100 Ethernet interface located next to the power jack as
shown in Figure 60 .
The PHY supports AutoMDX which means either a straight or a swap cable can be used
7.9 JTAG Connector
A place for an optional 20 pin CTI JTAG header is provided on the board to facilitate the
SW development and debugging of the board by using various JTAG emulators. This
header is not supplied standard on the board. To use this, a connector will need to be
soldered onto the board.
If you need the JTAG connector you can solder it on yourself. No other components are
needed. The connector is made by Samtec and the part number is FTR-110-03-G-D-06.
You can purchase it from www.newark.com.
10/100 Ethernet
Figure 60 Ethernet Connector