Manualshelf

User Manual

ManualsBrandsBeagleBoard Manuals32 Bit MicrocontrollersBeagleBoard BeagleBone Black Development Platform
81828384858687888990
7.7 microSD
A microSD connector is located on the backside of the board as shown in
Figure 59
below. The microSD card is not supplied with the board.
When plugging in the SD card, the writing on the card should be up. Align the card with
the connector and push to insert. Then release. There should be a click and the card will
start to eject slightly, but it then should latch into the connector. To eject the card, push
the SD card in and then remove your finger. The SD card will be ejected from the
connector.
Do not pull the SD card out or you could damage the
connector.
microSD
Conn
ec
tor
Figure 59 microSD Connector