User Manual

element14 is a trademark of Premier Farnell plc 39

Figure 23 TPS65217 DC Connection

A 5VDC supply can be used to provide power to the board. The power supply current

depends on how many and what type of add-on boards are connected to the board. For

typical use, a 5VDC supply rated at 1A should be sufficient. If heavier use of the

expansion headers or USB host port is expected, then a higher current supply will be

required.

The connector used is a 2.1MM center positive x 5.5mm outer barrel. The 5VDC rail is

connected to the expansion header. It is possible to power the board via the expansion

headers from an add-on card. The 5VDC is also available for use by the add-on cards

when the power is supplied by the 5VDC jack on the board.

6.1.3 USB Power

The board can also be powered from the USB port. A typical USB port is limited to

500mA max. When powering from the USB port, the VDD_5V rail is not provided to the