Installation & Assembly

9. Blade Assembly.
8.
C
anopy Assembly.
page 7
canopy set screw
canopy
10.Wall Control Operation.
0 - turns fan OFF
1 - turns fan to LOW speed
2 - turns fan to MEDIUM-LOW speed
3 - turns fan to MEDIUM speed
4 - turns fan to MEDIUM-HI speed
5 - turns fan to HI speed
Lift canopy until it covers hanging bracket
and touches ceiling. Tighten canopy set
screw to secure canopy.
blade
blade arm
motor housing
WARNING: To reduce the risk of serious bodily injury,
DO NOT use power tools to assemble the blades. If
screws are overtightened, blades may crack and break.
Locate 12 blade attachment screws and 12 decorative
nuts in hardware packs. Align holes in blade with holes
in blade arm. (Note label on blade arm indicating THIS
SIDE UP.) Push decorative nuts through holes in blade
from underside of blade and insert blade attachment
screws from topside. Tighten all 4 screws securely.
Repeat procedure with remaining blades.
Locate one of the rubber cushions on top of motor
housing. Remove the 2 larger screws (do not remove
center screw) but leave rubber cushion intact.
Lower blade arm over rubber cushion, attaching blade
arm with screws that were previously removed. Tighten
screws securely. Repeat with the remaining blades.
NOTE: Tighten blade arm screws twice a year.
decorative nuts
larger screws
blade attachment
screws