Assembly & Installation Instructions

Ball Nut G()
Glass Shade
Glass Holder
Socket Ring
Type A Max 60 W.
or ST Vintage Bulb
INSTRUCTIONS
NOTES 1. Before installing consult local electrical codes for wiring and grounding requirements:, .
WARNING:
TO AVOID RISK OF ELECTRICAL SHOCK BE SURE TO SHUT OFF,
POWER BEFORE INSTALLING OR SERVICING THIS FIXTURE.
Turn off the power at fuse or circuit box
Hardware Package included):(
Green Grounding
Screw E()
Headless
screw D()
Mounting Screw( )B
Wire Connector(C)
Lock Nut F()
Mounting plate(A)
Ball Nut G()
House Grounding Wire
Green Grounding Screw E()
Fixture Grounding Wire
Wire Connector(C)
Headless Screw (D)
Mounting Plate A()
Outlet Box
Fixture Wire
Lock Nut F()
Back Plate
1 Thread two headless screws through the mounting plate.,
and then secure them with four lock nuts (two on each side
of the mounting plate). Adjust the length of the headless
screws if necessary.
Note Make sure that the headless screws are lined up:
horizontally to make the fixture level.
2 Attach the mounting plate to the outlet box by using two.
mounting screws.
3 Pull out the source wires from the outlet box Make wire..
connections using follows:aswire connectors
---Connect the hot wire (usually black insulation) from the
fixture to the black wire from the power source.
---Connect the neutral wire (usually white insulation) from
the fixture to the white wire from the power source.
---Attach the fixture grounding wire (usually green insulation
or bare wire) to the mounting plate with the green grounding screw, and then connect it to the house grounding wire
with the .wire connector
Carefully tuck all wires back into the outlet box.
4 Attach the back plate to the mounting plate by inserting the headless screw and then secure it with the two ball nuts. ,.
2. READ AND SAVE THESE INSTRUCTIONS.
ASSEMBLY AND INSTALLATION
Installation steps
(not included)
Mounting Screw (B)