Assembly & Installation Instructions

1.Thread two headless screws through the mounting plate, then secure them with four lock nuts (two on each

side of the mounting plate). Adjust the length of the headless screws if necessary.

Note: Make sure that the headless screws are lined up horizontally, in order to ensure that the fixture will be

level.

Turn on the power at fuse or circuit box

Green Grounding

Screw (E)

Headless

screw (D)

Mounting Screw (B)

Wire Nut (C)

Lock Nut (F)

Mounting plate (A)

Ball Nut (G)

The following parts are available for re-order if damaged or missing.

Spare Parts List:

Mounting Hardware

(1 SET)

Glass Shade

A: 22

B: 8-1/4

C: 8

2. Attach the mounting plate to the outlet box by using two mounting screws.

Pull out the source wires from the outlet box. Make wire connections using wire nuts as follows:

---Connect the hot wire (usually black insulation) from the fixture to the black wire from the power source.

---Connect the neutral wire (usually white insulation) from the fixture to the white wire from the power source.

---Attach the fixture grounding wire (usually green insulation or bare wire) to the mounting plate with the green

grounding screw, and then connect it to the house grounding wire with the wire nut.

Carefully put the wires back into the outlet box.

4. Attach the back plate to the mounting plate by inserting the headless screw, then secure it with the two ball

nuts.

5. Attach the glass shade onto the glass holder and tighten it with the socket ring.

6. Install three bulbs (included). Check relamping label at socket area or packaging for maximum allowed wattage.